Yeti Communications Worldwide Ltd  est 2005

  

JCC MODEL JCD201M Bench Compression  Microphone

 $220NZD Couriered to your location

NEW IN!

JCC MODEL JCD201M Bench Compression Microphone

Selectable for 2 sets of transceivers at once by slide switch.
High Sensitivity Electret Condenser Microphone Element equipped.


High Quality Compressor Amplifier ( High - Low selectable ) built-in. It sends out constant and optimum level without distortion regardless of audio input level.


 Equipped with FM(AM)/SSB Audio Quality Selector Switch for optimum operation.

The Electret Condenser Microphone ensures clearer voice quality in FM(AM) position and better voice quality on SSB.


 Non-Modulation Prevention Circuit built-in.(timeout timer)
After continuous transmitting for a few minutes, the alarm circuit will be activated with alarm
sound for 30 seconds. Then, the condition returns to receiving mode automatically.


 Battery-Check Circuit built-in.
Turn the power switch on ( by selecting ''FM' or ''SSB'' position ), and the level meter indicates
the battery condition with power voltage for a few seconds.]

Amplification:
 High - 45dB
 Low - 35dB
 Manual 0--45db

Dual Microphone Connectors Output:
 Output A   8 Pin Standard Microphone Plug
 Output B   8 Pin Standard Microphone Plug
Front panel switch controlled.

Meter - Dual Display
 VU (Volume Unit)
 Battery Indicator
 1-1/2" H x 2" W

Buttons :
Output Select  Switch ~   A / B / OFF
Compression Level ~High - Low - Manual
Manual Compression Control Knob ~    Minimum ~ Maximum (0~_45db)
Mode Switch ~     SSB - FM _ Battery Check
Channel Control Switch ~  Up - Down
Key Controls ~  PTT  - PTT Lock
Output Voltage:
 Amplification - 0.3mv (Lapse)
 Variable Amplification: 0-70mv(Lapse)

Output Impedance:
500 ohm ~ 100k ohm

Batteries Required:
3 X AA  in some cases the radio can provide power to the microphone in these cases the batteries are not required (most 8 pin Yaesu / Icom or Kenwood transceivers)

Mic cable colour codes

1  Shield – Ground
2  Brown – Mic audio
3  White – Ground
4  Green – PTT +
5   Black – UP
6   Yellow – DOWN
7   Blue – UP/DOWN Ground
8  Red – 5-9 VDC power +

Please note this model microphone is only suitable for transceivers that do not have a receive wire in the mike line  (most cb radios)

or Transceivers with "TalkBack"

"Vox ready " for use with transceivers with "vox" ..Icom -Yaesu-Kenwood-Alinco .....

More Pics:

click on pics for larger view

Contact  Yeti Communications Ltd

CONTACT US VIA EMAIL

Contact us via Skype!  "Yeticomnz" Chat with me

This site is © Copyright www.survival-systems.com 2005-2010, All Rights Reserved.